HVAC
| HOME |
| ABOUT US |
| SERVICES |
| BIRDS |
| BEES |
| PRODUCTS |
| PROJECTS |
| RESIDENTIAL |
| COMMERCIAL |
| OTHER PEST |
| FAQ |
| PMP's |
| LINKS |
| HELP WANTED |
| CONTACT US |
Southwestern States Commercial Service 1.877.828.2473
Pigeon Bird Control Commercial Cooling & HVAC Units
Stand
Off brackets
They are mounted on the corners of the unit and support a perimeter cable approximately 2 feet above and 2 feet out from the outside edge of the unit. Two additional cables are installed diagonally from the end of each standoff support arm (corner to corner) to support the standoff arms and to provide support to the net in the middle of the unit, this insures that the net will not sag down onto the equipment
On
smaller units a cable tension system holds the standoff brackets securely in
place allowing installation without penetration of the HVAC unit with screws.
Adding two sheet metal screws per corner adds strength. Larger units with spans
greater than 10 feet should have sheet metal screws used to fasten the standoff
to the unit.
The protective net is net ringed to the supporting perimeter cable and down the corner seams. The weighted line is also net ringed securely to the bottom of the net to insure a clean and tight installation. A zipper can be installed in the net to allow access to the interior of the protection system. In the second example described here a 6' zipper is installed that allows easy access for maintenance.
Swamp Coolers - coming soon....
B4 / after pictures
Copyright © 2004 Arizona Wings-N-Stings All rights reserved. Revised: 05/04/08.